1 # uncomment if you get no picture on HDMI for a default "safe" mode
4 # uncomment this if your display has a black border of unused pixels visible
5 # and your display can output without overscan
8 # uncomment the following to adjust overscan. Use positive numbers if console
9 # goes off screen, and negative if there is too much border
15 hdmi_ignore_edid=0xa5000080
17 # uncomment to force a console size. By default it will be display's size minus
19 #framebuffer_width=1280
20 #framebuffer_height=720
21 framebuffer_height=1366
23 #framebuffer_height=1440
24 #framebuffer_width=800
25 #framebuffer_height=1280
26 #framebuffer_width=768
31 # uncomment if hdmi display is not detected and composite is being output
34 # uncomment to force a specific HDMI mode (this will force VGA)
39 # uncomment to force a HDMI mode rather than DVI. This can make audio work in
40 # DMT (computer monitor) modes
43 # uncomment to increase signal to HDMI, if you have interference, blanking, or
47 # uncomment for composite PAL
50 #uncomment to overclock the arm. 700 MHz is the default.
53 # for more options see http://elinux.org/RPi_config.txt