identical num steps on x and y, longer delay between onewire access

[reprap_mendel_prusa.git] / teacup_firmware / extruder / config.h

diff --git a/teacup_firmware/extruder/config.h b/teacup_firmware/extruder/config.h
index 474b971..ace2d67 100644 (file)
--- a/teacup_firmware/extruder/config.h
+++ b/teacup_firmware/extruder/config.h
@@ -74,11 +74,11 @@
 DEFINE_TEMP_SENSOR(extruder,    TT_THERMISTOR,      TEMP_PIN_CHANNEL,       THERMISTOR_EXTRUDER)\r
 //DEFINE_TEMP_SENSOR(bed,           TT_THERMISTOR,      TEMP_BED_PIN_CHANNEL,   THERMISTOR_EXTRUDER)\r
     //9 bits accuracy for faster conversion time\r
-DEFINE_TEMP_SENSOR(bed,         TT_ONEWIRE,     0,  9)\r
+DEFINE_TEMP_SENSOR(bed,         TT_DS1820,     0,  12)\r
 // dummy temp sensor so analog_mask includes trim pot\r
 DEFINE_TEMP_SENSOR(noheater,    TT_THERMISTOR,      TRIM_POT_CHANNEL,       0)\r
 #endif\r
-// DEFINE_HEATER(<name>, <pin>, <fan startup threshold pwm value>)\r
+// DEFINE_HEATER(<name>, <pin>, <invert?>, <fan startup threshold pwm value>)\r
 // fan startup threshold: FANs usually take more power to start spinning than to keep spinning,\r
 //                        so, below a given pwm value we start the fan with full power and after
 //                        50ms lower the output to the requested value.\r