teacup update, relocated Y-endpos sensor, use gcode e_absolute default

[reprap_mendel_prusa.git] / teacup_firmware / config.h

diff --git a/teacup_firmware/config.h b/teacup_firmware/config.h
index 9a32a76..bbce7de 100644 (file)
--- a/teacup_firmware/config.h
+++ b/teacup_firmware/config.h
@@ -143,7 +143,7 @@
 
        This is the startup default and can be changed with M82/M83 while running.
 */
-// #define E_ABSOLUTE
+#define E_ABSOLUTE
 
 
 
@@ -230,8 +230,8 @@
 
 #define        Y_STEP_PIN                                              DIO23
 #define        Y_DIR_PIN                                                       DIO22
-//~ #define    Y_MIN_PIN                                                       AIO6
-#define        Y_MAX_PIN                                                       AIO5
+#define        Y_MIN_PIN                                                       AIO6
+//~ #define    Y_MAX_PIN                                                       AIO5
 #define        Y_ENABLE_PIN                                    AIO7
 //#define      Y_INVERT_DIR
 //~ #define    Y_INVERT_MIN
@@ -258,7 +258,7 @@
 #define        SD_WRITE_PROTECT                        DIO3
 
 //#define      PS_ON_PIN                                                       DIO14
-#define        PS_ON_PIN                                                       PC5 // on TechZoneComm Motherboard, JTAG Port, TDI Pin
+#define        PS_ON_PIN                                                       PB5 // on TechZoneComm Motherboard, SPI Port: MOSI
 //#define      STEPPER_ENABLE_PIN              xxxx
 //#define      STEPPER_INVERT_ENABLE