reprap config file update, bootloader für motherboard

[reprap_mendel_prusa.git] / teacup_firmware / config.h

diff --git a/teacup_firmware/config.h b/teacup_firmware/config.h
index 03446d5..4f015d9 100644 (file)
--- a/teacup_firmware/config.h
+++ b/teacup_firmware/config.h
@@ -143,7 +143,7 @@
 
        This is the startup default and can be changed with M82/M83 while running.
 */
-// #define E_ABSOLUTE
+#define E_ABSOLUTE
 
 
 
@@ -230,8 +230,8 @@
 
 #define        Y_STEP_PIN                                              DIO23
 #define        Y_DIR_PIN                                                       DIO22
-//~ #define    Y_MIN_PIN                                                       AIO6
-#define        Y_MAX_PIN                                                       AIO5
+#define        Y_MIN_PIN                                                       AIO6
+//~ #define    Y_MAX_PIN                                                       AIO5
 #define        Y_ENABLE_PIN                                    AIO7
 //#define      Y_INVERT_DIR
 //~ #define    Y_INVERT_MIN
@@ -393,10 +393,8 @@ DEFINE_TEMP_SENSOR(bed,       TT_INTERCOM,    AIO1,      0)
        I have searched high and low for a way to make the preprocessor do this for us, but so far I have not found a way.
 */
 
-//#define      HEATER_EXTRUDER HEATER_extruder
+// workaround for heated bed over intercom. HEATER_EXTRUDER, HEATER_BED are the intercom temp channel numbers.
 #define        HEATER_EXTRUDER 0
-
-// workaround for heated bed over intercom. HEATER_BED is the intercom temp channel number.
 #define HEATER_BED 1