From: Bernhard Tittelbach <xro@realraum.at>
Date: Tue, 20 Aug 2013 03:07:47 +0000 (+0000)
Subject: identical num steps on x and y, longer delay between onewire access
X-Git-Url: https://git.realraum.at/?a=commitdiff_plain;h=ed897919312917bc55fe11f7977f982b05e21573;p=reprap_mendel_prusa.git
identical num steps on x and y, longer delay between onewire access
---
diff --git a/teacup_firmware/config.h b/teacup_firmware/config.h
index 2b4f9fb..e829616 100644
--- a/teacup_firmware/config.h
+++ b/teacup_firmware/config.h
@@ -66,12 +66,12 @@
//#define STEPS_PER_M_X 8000
//rechnerisch 8000, experimentell auf der X-Achse 8963.59
//rechnerisch 8000, experimentell auf der X-Achse 8075.67
-#define STEPS_PER_M_X 8200
+#define STEPS_PER_M_X 8000
// 200 steps / 20 gearteeth / 2.5mm (abtsand zahnriemen-zähne)
//#define STEPS_PER_M_Y 10047
-//#define STEPS_PER_M_Y 8000
+#define STEPS_PER_M_Y 8000
//rechnerisch 8000, experimentell auf der Y-Achse 8164.0
-#define STEPS_PER_M_Y 8110
+//#define STEPS_PER_M_Y 8110
//160000 für single step mit M8 Muttern, 320000 für half-step mit M8 Muttern
//200 steps / 1.25 * 1000 * 2
#define STEPS_PER_M_Z 320000
diff --git a/teacup_firmware/extruder/config.h b/teacup_firmware/extruder/config.h
index 474b971..ace2d67 100644
--- a/teacup_firmware/extruder/config.h
+++ b/teacup_firmware/extruder/config.h
@@ -74,11 +74,11 @@
DEFINE_TEMP_SENSOR(extruder, TT_THERMISTOR, TEMP_PIN_CHANNEL, THERMISTOR_EXTRUDER)
//DEFINE_TEMP_SENSOR(bed, TT_THERMISTOR, TEMP_BED_PIN_CHANNEL, THERMISTOR_EXTRUDER)
//9 bits accuracy for faster conversion time
-DEFINE_TEMP_SENSOR(bed, TT_ONEWIRE, 0, 9)
+DEFINE_TEMP_SENSOR(bed, TT_DS1820, 0, 12)
// dummy temp sensor so analog_mask includes trim pot
DEFINE_TEMP_SENSOR(noheater, TT_THERMISTOR, TRIM_POT_CHANNEL, 0)
#endif
-// DEFINE_HEATER(<name>, <pin>, <fan startup threshold pwm value>)
+// DEFINE_HEATER(<name>, <pin>, <invert?>, <fan startup threshold pwm value>)
// fan startup threshold: FANs usually take more power to start spinning than to keep spinning,
// so, below a given pwm value we start the fan with full power and after
// 50ms lower the output to the requested value.