X-Git-Url: https://git.realraum.at/?a=blobdiff_plain;f=reprap_mendel_prusa%2Fteacup_firmware%2Fconfig.h;h=4f015d900c1e9114a4bcfdfcc3cdf1664ef5b79d;hb=e7f6f1d123ecf2936e932269fc46b81f2a49e199;hp=9a32a763cedaac8e5692dd8df035956ca2f3772f;hpb=9eb72cb224a7380d4f9070f7cd895a1f147e0fee;p=svn42.git

diff --git a/reprap_mendel_prusa/teacup_firmware/config.h b/reprap_mendel_prusa/teacup_firmware/config.h
index 9a32a76..4f015d9 100644
--- a/reprap_mendel_prusa/teacup_firmware/config.h
+++ b/reprap_mendel_prusa/teacup_firmware/config.h
@@ -143,7 +143,7 @@
 
 	This is the startup default and can be changed with M82/M83 while running.
 */
-// #define E_ABSOLUTE
+#define E_ABSOLUTE
 
 
 
@@ -230,8 +230,8 @@
 
 #define	Y_STEP_PIN						DIO23
 #define	Y_DIR_PIN							DIO22
-//~ #define	Y_MIN_PIN							AIO6
-#define	Y_MAX_PIN							AIO5
+#define	Y_MIN_PIN							AIO6
+//~ #define	Y_MAX_PIN							AIO5
 #define	Y_ENABLE_PIN					AIO7
 //#define	Y_INVERT_DIR
 //~ #define	Y_INVERT_MIN
@@ -258,7 +258,7 @@
 #define	SD_WRITE_PROTECT			DIO3
 
 //#define	PS_ON_PIN							DIO14
-#define	PS_ON_PIN							PC5 // on TechZoneComm Motherboard, JTAG Port, TDI Pin
+#define	PS_ON_PIN							PB5 // on TechZoneComm Motherboard, SPI Port: MOSI
 //#define	STEPPER_ENABLE_PIN		xxxx
 //#define	STEPPER_INVERT_ENABLE
 
@@ -393,10 +393,8 @@ DEFINE_TEMP_SENSOR(bed,       TT_INTERCOM,    AIO1,      0)
 	I have searched high and low for a way to make the preprocessor do this for us, but so far I have not found a way.
 */
 
-//#define	HEATER_EXTRUDER HEATER_extruder
+// workaround for heated bed over intercom. HEATER_EXTRUDER, HEATER_BED are the intercom temp channel numbers.
 #define	HEATER_EXTRUDER 0
-
-// workaround for heated bed over intercom. HEATER_BED is the intercom temp channel number.
 #define HEATER_BED 1